Autoleveller

Just started using autolevller and so far a few successes. I few mishaps. Most on my part like missing a broken bit. Tonight I had one that I could not explain. Things seemed to start out all right so I left the machine to do its job. I really should have checked more and I might have more informati...

I will try bumping up the rpm. But I can't go too much higher. Have one of those cheap Chinese routers.

My blades are pretty new so doubtful that is it. But how often should I change out the blade?


Lubrication? I am not doing it at all. How should I lubricate?

Posted this on the Flatcam forum but it doesn't seem to get much activity there so thought I would try here too: I am milling PCBs. I am using Flatcam to produce the gcode and autoleveller to "level" the code. Over all it does a great job. But I am noticing what looks like "threads" of copper in bet...

Same here. I ran it again (after exiting Linuxcnc) and it just ran.

I am running g-code produced by the demo version of autoleveller for the first time. I am running it on linuxcnc. I touch the Z axis off about 10mm above the board as per the instructions on this site. When I run the code, the Z axis moves down and the bit makes contact with the board and stops. I t...