Autoleveller

I use a mechanical touch probe when I work with non conducting materials. After probing and changing to my preferred bit - should I do a "regenerate toolpath" before I continue executing the code or not? I'm using Mach 3.

Thanks I advance

This seams to be an issue with USB control boards and Mach3. See the thread here: http://www.cncsoftwaretools.com/forum/viewtopic.php?p=1128#p1128 There are a few options here, from writing a macro which will get the correct values from Mach3, to just swapping the control board drivers if possible....

Country_Bubba wrote:Dumb question, but what do you have your point spacing set to?? It acts like it is set to 0.

The spacing is set to 11 mm. I use the same setting on both direct leveling as I try to do and fail with the probing file.

I'm using Mach 3 with an USB controller and AE 0.9.2. After doing some custom controller settings everything works fine when doing a direct probe and etch. But when run a PFG for the same etch the produced RFP-file contains: 0.00000,178.38125,-2.04354 0.00000,178.38125,-2.04354 0.00000,178.38125,-2....

Hi I don't know if I'm doing something wrong but I can't seem to get my entries to show up in the saved *.nc I've seen others here that have succesfully entered commands and words to make AE work with mach3 with usb machines. When I hit apply my additions show up exactly as I want them to in the Exa...