This is a test to see if we can edit the posting.
Test Post
Moderator: Country_Bubba
- Country_Bubba
 - Posts: 124
 - Joined: Wed Oct 02, 2013 3:07 pm
 - Location: LaGrange, GA USA
 - Contact:
 
Test Post
Based on some problem reports, this is a test message to see how things are working. 
This is a test to see if we can edit the posting.
			
			
									
									This is a test to see if we can edit the posting.
Art
Country Bubba
						Country Bubba
Re: Test Post
Cheers Art, had some recent issues with the forum and wasnt sure how many were affected, if any. This helps a lot  
 
If anyone else has problems, please dont hesitate to let me know.
			
			
									
									If anyone else has problems, please dont hesitate to let me know.
http://www.autoleveller.co.uk/. Software to probe and adjust a GCode file for PCB's or any probe-able surface.
http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James
						http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James
- Country_Bubba
 - Posts: 124
 - Joined: Wed Oct 02, 2013 3:07 pm
 - Location: LaGrange, GA USA
 - Contact:
 
Re: Test Post
Seems to be working fine.  
 
Got notification and logged in with no problems to get to the post and obviously, can respond
			
			
									
									Got notification and logged in with no problems to get to the post and obviously, can respond
Art
Country Bubba
						Country Bubba
- Country_Bubba
 - Posts: 124
 - Joined: Wed Oct 02, 2013 3:07 pm
 - Location: LaGrange, GA USA
 - Contact:
 
Re: Test Post
Based on some recent changes, this once again is a test post to see if all is working. 
			
			
									
									Art
Country Bubba
						Country Bubba