Autoleveller

A place to discuss and comment on the autolevelling software
http://cncsoftwaretools.com/forum/

OpenBuilds blackbox with autoleveller

http://cncsoftwaretools.com/forum/viewtopic.php?f=8&t=1245

Page 1 of 1

OpenBuilds blackbox with autoleveller

Posted: Sat Aug 06, 2022 6:43 am
by Rozrabiaka
Hi, after generate gcode using autoleveller i have this error in OpenBuilds Control.
How to use autoleveller with OpenBuilds Control and Blackbox hardware?
Zrzut ekranu 2022-08-06 083221.png
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited