Autoleveller

Hi.. I work in desing and make of PCB for electronic circuit (is my hobby)
For make my prototypes I work whit LinuxCNC v. 2.8.4 and my electronic controller for CNC is Mesa 7I96 card
the software i work is Kicad + FlatCAM.

But I have problems with AutolevellerAE v.0.9.5u2.
when the axis X go to the right, all work fine, the height is correct and work perfect but when the Axis X change the direction, the Axis Z gou up a little more of the normal and no work fine and when the axis X change the direction again at the righ the axis Z go down and work fine again

This picture is whit Autoleveller


This picture is unautoleveller


The last picture my cnc work fine because is a small PCB

Someone know what going on?

Thanks you everyone

Hi, I fix the problem... the problem was the backlash parameter in the axis Z, I deactivate this option and now work fine

At now the my CNC make PCB like that




This software work really great, thanks you so much

Hi,
Glad you were able to figure it out! Some of the settings can be inter reactive and hard to chase down.
Good Job