[SOLVED] Autoleveller no work fine when the axis X change of direction

[Nest]

Hi.. I work in desing and make of PCB for electronic circuit (is my hobby)
For make my prototypes I work whit LinuxCNC v. 2.8.4 and my electronic controller for CNC is Mesa 7I96 card
the software i work is Kicad + FlatCAM.

But I have problems with AutolevellerAE v.0.9.5u2.
when the axis X go to the right, all work fine, the height is correct and work perfect but when the Axis X change the direction, the Axis Z gou up a little more of the normal and no work fine and when the axis X change the direction again at the righ the axis Z go down and work fine again

This picture is whit Autoleveller


This picture is unautoleveller


The last picture my cnc work fine because is a small PCB

Someone know what going on?

Thanks you everyone

[Nest]

Hi, I fix the problem... the problem was the backlash parameter in the axis Z, I deactivate this option and now work fine

At now the my CNC make PCB like that




This software work really great, thanks you so much

[Country_Bubba]

Hi,
Glad you were able to figure it out! Some of the settings can be inter reactive and hard to chase down.
Good Job