In case you have missed it, there is a new version of AE out!
AutoLevellerAE (Advanced Edition) Version 0.9.0 and it has a fantastic new feature where the toolpath is traced out for the etching of the board.
Check it out.
AutoLeveller updates
-
Country_Bubba
- Posts: 124
- Joined: Wed Oct 02, 2013 3:07 pm
- Location: LaGrange, GA USA
- Contact:
Re: AutoLeveller updates
Hey All,
In case you have missed it, there is a new version of AE out!
AutoLevellerAE (Advanced Edition) Version 0.9.0 and it has a fantastic new feature where the toolpath is traced out for the etching of the board.
Check it out.
In case you have missed it, there is a new version of AE out!
AutoLevellerAE (Advanced Edition) Version 0.9.0 and it has a fantastic new feature where the toolpath is traced out for the etching of the board.
Check it out.
Art
Country Bubba
Country Bubba
0.9.0 AutoLevellerAE prode data and screen size
Great to be able to see the gerber BUT...
2 problems in 0.9.0
I can't resize the window to fit myCNC machine's old 1024x768 screen - the right side is cut off which of course has the "autolevel" button on it. I have gone back to 0.8.5 for now. I hope this is fixed soon! and
There is no probe data at the top of the GCode file to enable resuming after a tool breakage. (same in 0.8.5). Is there a way of getting it back? Or some other method of finding a reference XY to reset Z?
Cheers,
Brenton from Australia
2 problems in 0.9.0
I can't resize the window to fit myCNC machine's old 1024x768 screen - the right side is cut off which of course has the "autolevel" button on it. I have gone back to 0.8.5 for now. I hope this is fixed soon! and
There is no probe data at the top of the GCode file to enable resuming after a tool breakage. (same in 0.8.5). Is there a way of getting it back? Or some other method of finding a reference XY to reset Z?
Cheers,
Brenton from Australia