Autoleveller

Hey All,
In case you have missed it, there is a new version of AE out!

AutoLevellerAE (Advanced Edition) Version 0.9.0 and it has a fantastic new feature where the toolpath is traced out for the etching of the board.

Check it out.

Great to be able to see the gerber BUT...
2 problems in 0.9.0
I can't resize the window to fit myCNC machine's old 1024x768 screen - the right side is cut off which of course has the "autolevel" button on it. I have gone back to 0.8.5 for now. I hope this is fixed soon! and

There is no probe data at the top of the GCode file to enable resuming after a tool breakage. (same in 0.8.5). Is there a way of getting it back? Or some other method of finding a reference XY to reset Z?
Cheers,
Brenton from Australia